Selecting An Approach; Appendix - Garmin GTN 625 Pilot's Manual

6.4

Selecting an Approach

Only one approach can be loaded at a time in a flight plan. If an approach
is loaded when another approach is already in the active flight plan, the new
approach replaces the previous approach. The route is defined by selection of an
approach, the transition waypoint, and a runway.
In software v6.21 and later, the pilot may load an alternate
NOTE:
approach during a missed approach procedure. The GTN retains all
missed approaches in the flight plan.
1. Touch the PROC key on the Home page. The Approach, Arrival,
and Departure fields will be dashed until a selection is made.
2. Touch the Approach key on the Procedures page to select
an approach for the destination airport. Confirm that the
intended airport is shown or touch the Airport key and select
the desired airport.
NOTE: If using Descent VNAV, verify that the altitudes for the selected
procedure match the charted or ATC cleared altitudes and are appropriate
for the airframe type.
Touch to Select
Airport
190-01004-03 Rev. P
Figure 6-15 Procedures Selection Window
Figure 6-16 Selecting an Approach
GTN 625/635/650 Pilot's Guide
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
Direct-To
Proc
Wpt Info
Touch to Select
Departure
Map
Touch to Select
Arrival
Traffic
Touch to Select
Approach
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Touch to Select
Approach
Symbols
Touch to Select
Channel ID

Appendix

Index
6-9
FPL