Garmin GTN 625 Pilot's Manual page 151

6. If desired, touch the Channel/ID key, then use the numeric
keypad to select the channel number, and then touch the Enter
key. The Channel and ID are typically loaded automatically if
they are present.
NOTE: As an alternate means of loading an approach, the Channel ID key
allows you to select the channel ID for a SBAS approach for the current
destination. The channel ID for the SBAS approach is available from an
approved approach chart. If duplicate numbers are available for a channel,
a list will be available where you may select the desired approach.
7. Touch the Preview key.
Sequence List
for Selected
Transition
Approach
Diagram
8. Touch the Load Approach key. The Active Flight Plan page
will be displayed. The approach waypoints are placed at the
end of the flight plan and the unit will automatically sequence
to them after the en route waypoints.
190-01004-03 Rev. P
Figure 6-20 Selected Approach Preview
GTN 625/635/650 Pilot's Guide
Foreword
Com/Nav
Unselected
Transition
Selected
Transition
Touch to Activate
Approach
Messages
Appendix
6-11
Getting
Started
Audio &
Xpdr Ctrl
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Symbols
Index