Selecting Com/Nav Frequencies - Garmin GTN 625 Pilot's Manual

1.7

Selecting Com/Nav Frequencies

Com Standby Editing Window
Standby Frequency Monitor Key
Frequency Transfer
(Flip/Flop) Key
Volume
and
Squelch
Find
Frequency
Key
Figure 1-20 Com Radio Frequency Selection Page
To switch between Com and Nav frequency selection
Tuning control normally remains in the Com window and will return after 30
seconds of inactivity. If you wish to select a NAV frequency, press the small right
knob momentarily to make the Nav window active for editing. The Standby Nav
frequency will be highlighted briefly to indicate that it is active for editing. The
standby frequency in blue is active for editing by the large and small right
knobs.
Method 1: Select a Nav/Com frequency using the small and large right rotary
knobs
1. Turn the large right knob to select the desired megahertz
(MHz) value. For example, the "119" portion of the frequency
"119.30."
2. Turn the small right knob to select the desired kilohertz
(kHz) value. For example, the ".30" portion of the frequency
"119.30."
3. Touch the Com or NAV window to flip/flop the Active and
Standby frequencies. You can also press and hold the small
right knob to transfer the standby frequency to the active
window.
190-01004-03 Rev. P
Numeric Keypad
GTN 625/635/650 Pilot's Guide
Standby Frequency Backspace Key
Active Com Frequency
Standby Com
Frequency
Large and Small Knobs
(Frequency Adjust).
Press to Toggle Com
and Nav Functions.
Enter Key
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
1-15