Esc Gs X S 3 N; Esc Gs X P - Star StarPRNT SM-L Series Command Specifications

ESC GS x S 3 n

[Name] Set PDF417 module aspect ratio
[Code] ASCII ESC GS
Hex. 1B
Decimal 27
[Defined Area] 1 ≤ n ≤ 10
[Initial Value] n = 3
[Function] Parameter details
• n:
The module Y direction size (x-dim x asp) is set using this command.
It is recommended that 2 ≤ n when specifying using this command.
When using with n = 1, check by actual use.
ESC GS x D nL nH d1 d2 ... dk
[Name]
Set PDF417 bar code data
[Code] ASCII ESC GS
Hex. 1B
Decimal 27
[Defined Area] 0 ≤ nL ≤ 255, 0 ≤ nH ≤ 255
1 ≤ (nL + nH x 256) ≤ 1024
0 ≤ d ≤ 255
1 ≤ k ≤ 1024
[Initial Value] ---
[Function] Parameter details
When [nL + nH x 256] is outside of the definition, data of [nL + nH x 256] bytes is discarded.
[Model Limitations] SM-L200 : Maximum data size 128 Bytes

ESC GS x P

[Name]
Print PDF417 bar code
[Code] ASCII ESC
Hex. 1B
Decimal 27
[Defined Area] ---
[Initial Value] ---
[Function] Prints the bar code data.
If there is unprinted data in the line buffer, this command is executed after printing that data in the line
buffer. Therefore, it is not possible to print with other data in the same line (characters, bit images, bar
codes).
Also, this command is ignored if the following errors occur.
• When an error is generated when generating a bar code, due to the combination of the bar code setting
commands
• When the bar code data that is generated exceeds the printable size of PDF417
• When the print data exceeds the currently set print region
When a bar code is printed, always verify it by actual use.
Star PRNT Command Specifications
x S 3 n
1D 78 53 33 n
29 120 83 51 n
Sets the module aspect ratio (asp).
x D nL nH
1D 78 44 nL nH
29 120 68 nL nH
• nL + nH x 256 : Bar code data count
• dk : Bar code data (Maximum 1024 data)
GS x P
1D 78 50
29 120 80
d1 d2 ... dk
d1 d2 ... dk
d1 d2 ... dk
2-71