Star mC-Print3 Easy Setup Manual

80878670
Easy Setup Guide
Introduction
This document explains the procedures for use of mC-Print3. Please store it carefully after reading it.
Check the Supplied Accessories
If any of the package contents are missing or damaged, contact the dealer where the
product was purchased.
AC Adapter Power Cable*
MCP30 USB Cable*
What the utility can do

The utility can be used to change the settings of the printer and peripheral devices.
Examples) • LAN settings • memory switch changes, logo registration
• Sample printing • Firmware update/diagnosis etc.
● To use the utility, download it from the site at right.
● To perform setup using this manual, proceed to Step
In Case of Trouble
If you experience trouble with the setup procedure, refer to the Online Manual.
Place the enclosed flyer close to the printer and use it when necessary.
Installing the Printer
1
Installing the paper roll
 When using a 58 mm roll, install the pro-
vided paper roll guide.
Pull the open lever  and open the printer
With the notch part A (triangle mark) of the
.
cover 
paper roll guide facing down, angle the guide
to the right and insert it
Position so that the notch part A is aligned
with the main unit rib B, then slide the guide
2
from the right
1
Take the slack of the paper roll before paper
setting, insert the paper roll as shown in the
illustration.
When the slid paper roll guide stops, stand
it up vertical
place 
Pull the end of the paper roll out straight  ,
and use both hands to close the printer cover
 .
To change the paper width, it is necessary to
3
4 change the memory switch setting. For de-
tails, refer to the Online Manual.
4
*
Accessories vary depending on the region where the printer was purchased.
This Manual
Paper Roll Safety Easy
Paper Roll Setup Guide
Guide Instructions
mC-Print3 Utility Download
www.star-m.jp/mcprint-app.html
1
.
mC-Print3 Online Manual
www.star-m.jp/mcprint3-oml.html
2
Turning ON the main unit power
Place your nails into the gaps in the right and
left sides of the rear cover on the back of the
printer, and then remove the cover.
 .
 .
B
2
Connect the power cable to the AC adapter
A
1
 , and connect the cable connector to the
printer as shown in the illustration
the plug into the outlet
2
 , and press until it clicks into
.
Press the power button
3
the LED (blue) illuminates
4
5
Connecting a Tablet or PC to the Printer
3
-A
Connecting an iOS terminal to the printer
You will need:
• Commercially-available LAN cable
Flyer
(Q&A reference)
Image of connection
 DHCP is enabled by default for the wired LAN settings.
To continually use the same IP address, set a static IP ad-
dress before use.
For the static IP address setting procedure, refer to the
Online Manual.
Installing the rear cover
 . Insert
 .
Installing the rear cover onto the back of

the printer
3
1
Press the hooks A at the bottom of the rear cover into
the notches in the printer main unit
 and confirm that
B on the left and right of the rear cover into the printer
 .
main unit until they click into place
4
Wired LAN
interface
Connect the LAN cable to the printer LAN connector
LAN
Printer-side plug
Connect the other plug to the connector of the router, hub, or other
LAN device  .
2
, then fit the hooks

 . 2
B
 .
1
1
A
B