Esc/Pos Mode Commands (Tm-295 Emulation) - Star SP298 SERIES User Manual

ESC/POS Mode Commands (TM-295 emulation)

The following table lists the TM-295 emulation commands that are supported
by this printer.
Control Codes
<HT>
<LF>
<FF>
<DLE> <EOT>
<CAN>
<ESC> SP
<ESC> !
<ESC>#
<ESC> %
<ESC> &
<ESC> *
<ESC> 2
<ESC> 3
<ESC> =
<ESC> @
<ESC> C
<ESC> D
<ESC> F
<ESC> J
<ESC> K
*1: n/60-inch line spacing and paper feed commands:
Since the minimum paper feed pitch for this printer is 1/144 inch, n/60 inch can
considered an approximate value. However, the actual value is INT ((6n/5) +
0.5)/72 inch.
Hexadecimal
Codes
09 Horizontal tab
0A Line feed
Paper eject in single sheet mode
0C
Paper mode print and return
10 04 Enables real-time status send (Serial I/F only)
18 Cancels print data in page mode
1B 20 Sets size of space to right of character
1B 21 Enables batch print mode
1B 23 Sets memory switch
1B 25 Enables/disables download character set
1B 26 Defines download character
1B 2A Selects bit image mode
1B 32 Selects 1/6-inch line spacing
1B 33 Selects approximate n/60-inch line spacing *1
1B 3D Selects peripheral device
1B 40 Initializes the printer
1B 43 Sets the eject length for single-sheet printing
1B 44 Sets horizontal tab position
1B 46 Enables/disables reverse feed for single-sheet mode
1B 4A Prints and n/60-inch (approximate value) paper feed *1
1B 4B Prints and n/60-inch (approximate value) reverse paper feed *1
Function
26