Pts Setup Menu; Factory Adjustment Menu; Alarm Setup Menu - TANDBERG TT1220 Series Instruction Manual

Menus
C.3.14 PTS Setup Menu
The PTS setup menu, allows the user to configure a offset for the audio, in
relation to the PTS (Presentation Time-stamp). This is useful for correcting
lipsync generated on the encoder (or earlier) stage in the transmission
process.
Table C.16: PTS Setup Menu
Display title: OUT: PTS SETUP
Aud delay ms
C.3.15 Factory Adjustment Menu
The factory adjustment menu contains parameters (video gain, chroma
gain, audio level fine tuning), that is preset to the correct level when
shipped from TANDBERG Television.
However, should there be a need to change these values, you may call
TANDBERG Television support, at the number shown in the Preliminary
pages of this manual, to obtain the necessary PIN to access these menus.
Table C.17: Factory Adjustment Menu
Display title: OUT: FACTORY
ADJ.
Password
C.3.16 Alarm Setup Menu
The alarm setup menu, is a hub-menu, where the submenus contain all
the configurable alarm parameters, sorted into groups. The alarm
parameters may be configured into three levels of severity; alarm (A),
warning (W), or ignore (-).
Table C.18: Alarm Setup Menu
Display title: ADV: ALARM
SETUP
Input
PSI/SI
CA
Video
VBI
Audio
Audio2
Data
Config
For further information on what the different alarms mean, refer to the
alarm chapter, Annex D, Alarm Categories and Conditions.
Page C-10
Description
+/- 999 ms selectable, in 1 ms steps
Description
A 8 digit number has to be entered, to access the factory settings
submenu.
Description
Input alarms submenu
PSI/SI related alarms submenu
CA related alarms submenu
Video related alarms submenu
VBI related alarms submenu
Audio related alarms submenu
Audio2 related alarms submenu
Data output related alarms submenu
Errors related to the configuration of the unit
Instruction Manual: Professional Receivers and Decoders (IRD)
Section
Section
Section
ST.TM.TT1220.1