Connecting Mains Power; Signal Connections - Roksan Audio K3 Manual

Please refer to the front & rear panel view on Pages 6 & 7. The moulded IEC
connector of the supplied mains lead should be plugged into socket (27)
on the rear of the unit first and then plugged into the mains supply.
The mains power switch (15) is on the front under side of the Integrated
Amplifier. This switch can be left on; if however the amplifier is likely to be
unattended for a long period of time, switch it off and unplug the mains
lead from the wall.
There are 6 Inputs (18 -24) on your K3 Integrated Amplifier. Except for
PHONO input (19) all other inputs are line level and will accept virtually all
currently available source components. The PHONO input is factory set for
Moving Magnet Cartridges to accommodate record players fitted with MM
phono cartridges. The AV input (22) is linked to the BYPASS input (18) and
switch to set BYPASS, then the AV input will be deactivated and the BYPASS
input will become activated. In this mode, the BYPASS input can be used to
a surround sound processor's front L & R pre output for home theatre use.
The BYPASS input is directly connected to the power amp section and
bypasses the preamp. The volume is then controlled via the surround
sound processor and not the K3 Integrated. You could also use the
integrated as a power amp in this mode.
All the inputs use gold plated RCA phono connectors and should be
connected according to the standard convention.
-
Right Channel - Red
-
Left Channel - Black or White
Also in accordance with standard practice, the upper row of phono Sockets
carries the Left Channel and the lower row carries the Right Channel.
Page 8
c/o Monitor Audio Ltd, 24 Brook Road, Rayleigh, Essex, SS6 7XJ
www.roksan.co.uk | info@roksan.co.uk | +44 (0)1268 740580
Set-Up

Connecting mains Power

Signal Connections

Roksan Audio ROK-1217 V2.3
April 2018