Roksan Audio K3 Manual page 10

amplifier terminal. When both left and right channels are connected to the
respective speakers the amplifier is ready for use.
IMPORTANT NOTE: For optimum performance it is recommended to use
high quality inter-connect cable such as ROKSAN HDC-03A High Definition
Analogue Cable.
IMPORTANT NOTE: For optimum performance it is recommended to use
high quality cable such as ROKSAN HDC 03S High Definition Loudspeaker
Cable. Many speaker cables such as the ROKSAN HDC-03S are directional.
Please observe this characteristic. DO NOT use a speaker cable with
conductor size less than 16 AWG (1.6mm Diameter). The binding posts
accept conductor sizes up to 12 AWG.
Multi-amping Loudspeakers
If the system loudspeakers utilise more than one drive unit with individual
input terminals, for example a Tweeter and Woofer, then the loudspeakers
performance should benefit from bi-amping by use of the addition of a K3
Power Amplifier. Dedicating one amplifier to the Tweeter and another to
the Woofer isolates them from each other, hence reducing distortion and
increasing reserved power. Speakers work significantly better with most
amplifiers when multi-amped than using one, more powerful, amplifier.
For setup and connection details on multi-amping refer to the K3 Power
Amplifier Manual.
Multi-wiring Loudspeakers
NOTE: Multi-Wiring connects the Woofer and the Tweeter terminals directly
to the output terminals of the amplifier and is the first step towards Multi-
Amping.
Page 10 Roksan Audio ROK-1217 V2.3
c/o Monitor Audio Ltd, 24 Brook Road, Rayleigh, Essex, SS6 7XJ
April 2018
www.roksan.co.uk | info@roksan.co.uk | +44 (0)1268 740580