Connecting Mains Power; Signal Connections; Loudspeaker Connections - Roksan Audio Kandy L III User Manual

S E T - U P

CONNECTING MAINS POWER

Please refer to rear panel view on Page 4. The moulded IEC connector of the supplied mains lead should be
plugged into the socket (10) on the rear of the unit first and then plugged into the mains supply. The Mains power
switch (9) is on the rear panel of the Amplifier. This switch is normally left on. If the unit is likely to be unattended
for a long period, switch it off and unplug the mains lead from the wall.

SIGNAL CONNECTIONS

Signal Input Connections:
'Trim-able' Inputs (4) and the
Input Selector Switch (3) should be set to 'Straight' or 'Trimmed' according to the inputs that are intended for use.
All the inputs use Gold plated RCA Phono Connectors and should be connected according to the standard
convention – Right Channel – Red;
Also in accordance with standard practice, the Upper row of Phono Sockets carries the Left Channel and the
Lower row carries the Right Channel.
The Input Sockets are labeled with their legends upside down as well as the normal way up to assist you should
you be connecting an input from a position in front of and above the amplifier.
Straight Input Connections:
for multi-amping with the Kandy Integrated or purely as a power amplifier, you should connect the pre out of your
Kandy Integrated , pre-amplifier or surround sound processor to the corresponding Straight Input. The gain of the
Kandy Power Amplifier is exactly the same as the power amplifier section of the Kandy Integrated Amplifier and
therefore is ideal for Multi-amping (Bi-amping, Tri-amping etc.)
IMPORTANT NOTE: For optimum performance it is recommended to use high quality inter-connect cables
such as ROKSAN HDC-02A high definition analogue Cable.
Trimmed Input Connections:
for Multi-channel A/V, directly connected to the Kandy DVD 5.1 Dolby Audio output, or as a power amplifier in
an installation requiring its output level to be trimmed down, then the Trimmed Inputs should be used. (e.g. You
should connect the Kandy DVD audio output to the corresponding Trimmed Input of the Kandy Power Amplifier)
panel.
IMPORTANT NOTE: It is always better to use the Straight Inputs when there are no requirements for level
adjustment.

LOUDSPEAKER CONNECTIONS

The Right and Left loudspeakers are connected to the amplifier via the rear panel binding posts (6) and (7)
respectively. There are two basic types of cable –
•
Figure 8 cable has two insulated conductors that lie parallel, either side by side, or spaced by insulation.
•
Overall sheathed cable has both conductors insulated and enclosed in an overall plastic sheath.
Roksan Audio ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE
There are two types of input on the Kandy Power Amplifier, the
'S'
column of L & R 'Straight' Inputs (5).
First set the Input Selector Switch (3) to 'STRAIGHT'. If you wish to use the amplifier
First set the Input Selector Switch (3) to 'TRIMMED'. If you wish to use the amplifier
These Inputs can then be fully trimmed down by using the Trimmers (1, 2) on the back
K a n d y Power Amplifier 2 Channel
Left Channel – Black
Kandy Power Amplifier 2-Channel User Manual
Page 5 of 10
'T'
column of L & R
or White.
Version 1.01
ENGLISH