Roksan Audio K3 Manual page 13

NOTE: If you wish to revert to a line level or the MM phono input, push the
Bluetooth on/off button and it will disconnect and the light will turn off. You
can then select the required input as per normal operation. To reconnect to
Bluetooth you must push the Bluetooth on/off button again. You will then
have to re-connect the device (at which point the blue light will stop
flashing and remain on) but pairing is not necessary.
Knowing Your K3
When you first power up from the Mains Switch the amplifier will be fully
operational.
If the amplifier output current exceeds its safe operating range (very low
loudspeaker impedance and/or very high volume level) the protective
circuitry of the K3 will take the amp into Protection mode. If subsequently
lowered or the loudspeakers changed, the amplifier can be brought out of
the Protection state to resume as normal.
Page 13 Roksan Audio ROK-1217 V2.3
c/o Monitor Audio Ltd, 24 Brook Road, Rayleigh, Essex, SS6 7XJ
April 2018
www.roksan.co.uk | info@roksan.co.uk | +44 (0)1268 740580