Table of Contents
Advertisement
1.
Preamp Output 2 (Multi-Amping or Subwoofer)
2.
Preamp Output 1 (Multi-Amping or Subwoofer)
3.
Tape Input (Playback)
4.
Tape Output (Record)
5.
Phono Input
6.
Line 2 Input
7.
Line 1 Input
8.
Video Input
9.
Tuner Input
10.
CD Input
11.
Right Speaker Output
12.
Left Speaker Output
13.
Voltage & Fuse Label
14.
AC Mains Power Switch
15.
AC Mains Input
16.
AC Mains Fuseholder
17.
Phono Input Grounding Terminal
S E T U P
CONNECTING MAINS POWER
Please refer to rear panel view on Page 4. The moulded IEC connector of the supplied mains lead should be
plugged into the socket (15) on the rear of the unit first and then plugged into the mains supply. The Mains power
switch (14) is on the rear panel of the Integrated Amplifier. This switch is normally left on. If the unit is likely to be
unattended for a long period, switch it off and unplug the mains lead from the wall.
S
I
G
N
A
L
C
O
N
N
E
C
T
S
I
G
N
A
L
C
O
N
N
E
C
T
Signal Input connections:
Input (3). Except for the PHONO input (5), all other inputs are line level and will accept virtually all currently
available source components. The PHONO input is factory set for Moving Magnet Cartridges to accommodate
record players fitted with a MM phono cartridge. (This input can be set by Roksan or Roksan appointed service
centres to Line Level input if so required.)
All the inputs use Gold plated RCA Phono Connectors and should be connected according to the standard
convention – Right Channel – Red; Left Channel – Black or White.
Also in accordance with standard practice, the Upper row of Phono Sockets carries the Left Channel and the
Lower row carries the Right Channel.
The Input Sockets are labeled with their legends upside down as well as the normal way up to assist you should
you be connecting an input from a position in front of and above the amplifier.
MC Input Connections:
be connected to the Phono Input. Alternatively a dedicated Phono Stage can be connected to a Line level Input
(NOTE: If you wish to connect to the Phono Input, it must be set for Line level signal. See above). For advice and
demonstration of ROKSAN state of the art turntable reproduction systems contact your authorised retailer.
IMPORTANT NOTE: For optimum performance it is recommended to use high quality inter-connect cables such
as ROKSAN HDC-02A high definition analogue Cable.
LOUDSPEAKER CONNECTIONS
The right and left loudspeakers are connected to the amplifier via the rear panel binding posts (11) and (12)
respectively. There are two basic types of cable –
•
Figure 8 cable has two insulated conductors which lie parallel, either side by side, or spaced by insulation.
•
Overall sheathed cable has both conductors insulated and enclosed in an overall plastic sheath.
Roksan Audio ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE
I
O
N
S
I
O
N
S
There are six Inputs (5 – 10) on your Kandy Integrated Amplifier in addition to the Tape
If you wish to use a Moving Coil cartridge, an in-line MC step-up transformer should
K a n d y Integrated Amplifier
Kandy Integrated Amplifier User Manual
Page 5 of 11
Version 3.3
ENGLISH
Hide quick links:
Advertisement
Table of Contents
