NAiS GT Series Technical Manual page 94

Setting the communication conditions
Setting communication conditions on the GT side
Set the COM. port communication conditions as follows.
Item
Baud rate
Data length
Parity check
Stop bit
Setting communication conditions on the PLC side
Set the communication conditions as follows. Some items cannot be set depending on the used model.
There is no need to set the items that are not available.
Item
PLC mode
Mode designation
Procedure
Baud rate
Data length
Parity check
Stop bit
Unit No.
CTS designation
5 V supply
Communication system
Note) Be sure to use the PLC in monitor mode.
4-34
Value set
19200 bps
7 bits
Yes, Even
1 bit
Value set
Monitor mode
High link
1:N
19200 bps
7 bits
Yes, Even
1 bit
No. 0
Always ON
None
RS232C