NAiS GT Series Technical Manual page 146

TOOL port communication parameter settings (GTWIN communication parameter settings)
Through function: Through function destination setting (** part)
When the through function is being used, this specifies the number of the PLC of the connection.
Normally, when used in a 1:1 configuration, this should be set to "00".
Bitrate: PLC baud rate
Each time the [Function] key is touched, the baud rate switches in the sequence of 9600, 19200, 115200.
Set the baud rate to match that of the personal computer (GTWIN) connected to the GT main unit.
Format: Transmission format
This sets the communication parameters (data length, stop bits, parity) for the personal computer
(GTWIN) connected to the GT main unit.
The items displayed are: Data length/Stop bit/Parity, and each time the [Function] key is pressed, the
display switches in the sequence of: [8/1None], [8/1/Odd], [8/1/Even].
Touch panel operation:
[RETURN] To complete the settings and return to the previous screen, touch the [ESC] key.
Explanation of this function:
The default values for the TOOL port communication parameter settings are: 115200, 8/1/Odd.
5-22
Procedure for bringing up the screen
[Initial screen]
↓
[Setting]
↓
[COM. Port]