NAiS GT Series Technical Manual page 86

Setting the communication conditions
Setting communication conditions on the GT side
Set the COM. port communication conditions as follows.
Item
PLC unit
Baud rate
Data length
Parity check
Stop bit
Setting communication conditions on the PLC side
Set the communication conditions as follows. Some items cannot be set depending on the used model.
There is no need to set the items that are not available.
Item
Unit No.
Baud rate
Data length
Parity check
Stop bit
Checksum
Interface
Dedicated protocol control procedure
Usable devices
Device type
Input relay
Output relay
Internal relay
Bit
device State
Timer (contact)
Counter (contact)
Input relay
Output relay
Internal relay
Link relay
Word
Timer (current value)
device
Counter (current value)
Data register
Link register
File register
4-26
Value set
0
19200 bps
7 bits
Even
1 bit
Value set
0
19200 bps
7 bits
Even
1 bit
Available
RS232C
Format 4
FX1N range No.
X0000 to X07FF
Y0000 to Y07FF
M0000 to M2047
B0000 to B03FF
TS0000 to TS0255
CS0000 to CS0255
X0000 to X07F0
Y0000 to Y07F0
M0000 to M2032
B0000 to B03F0
TN0000 to TN0255
CN0000 to CN0255
D0000 to D1023
W0000 to W03FF
R0000 to R8191
Remarks
Designate the address of first digit with 0.
Designate the address of first digit with 0.
Designate the address in increments of 16
Designate the address of first digit with 0.