Table of Contents
Advertisement
"Basic Setup" screen (for GT10 and GT30)
• Title: The title of the configuration settings file is entered here. Titles are convenient if each GT main
unit has its own configuration settings.
• PLC Model: The model of PLC specified when GTWIN is booted is displayed here.
• GT Model: The model of GT specified when GTWIN is booted is displayed here.
• Basic Communication area to PLC: This is used to specify the mode in which communication takes
Device used
This specifiesthe internal PLC device used for basic communication between the GT main unit and PLC.
Word area:
This specifies the type of device that reads and writes screen numbers and other
information in word units, and the initial address.
Bit area:
This specifies the type of device that reads and writes backlight control and other bit
information, and the initial address.
The type of device and addresses can be set by clicking on the
Device settings dialog box
Reference: <3.2.3 GT01 Basic Communication Area Map>
5-4
place between the Gtmain unit and PLC, and the internal PLC
device used for basic communication.
Clicking on the
button displays a pull-down menu. Select the device
for which settings are to be entered, and use the ten-keys to enter
addresses.
The
button functions as a backspace key when entering
addresses.
The
button acts as a Clear key.
buttonsfor the various items.
Advertisement
Table of Contents
