NAiS GT Series Technical Manual page 123

Setting the communication conditions
Setting communication conditions on the GT side
Set the COM. port communication conditions as follows.
Item
PLC unit No.
Baud rate
Data bit
Parity check
Stop bit
Setting communication conditions on the PLC side
Set the communication conditions as follows. Some items cannot be set depending on the used model.
There is no need to set the items that are not available.
Item
Unit No.
Baud rate
Data bit
Parity check
Stop bit
Checksum
Termination character designation
Usable devices
Device type
Input relay
Output relay
Bit Internal relay
device
Link relay
Timer
Counter
Input relay
Output relay
Internal relay
Word
Link relay
device
Timer (current value)
Counter (current value)
Data register
Link register
File register
Value set
1
19200 bps
8
None
1 bit
Value set
1
19200 bps
8
None
1 bit
None
Available
No.
X00201 to X71664
Y00201 to Y71664
I00001 to I16000
L00001 to L08192
T0001 to T3072
C0001 to C3072
X00201 to X71649
Y00201 to Y71649
I00001 to I15985
L00001 to L08177
TP0001 to TP3072
CP0001 to CP3072
D00001 to D65535
W00001 to W08192
B00001 to B99999
Remarks
Designate the slot No. (1 digit) + unit No. (2
digits) + terminal No. (2 digits).
Designate the slot No. (1 digit) + unit No. (2
digits) + terminal No. (2 digits).
Designate the system No. (1 digit) + link
relya No. (4 digits). The system No. 0 is
only available.
Designate the last 2 digits of the address to
be 17, 33, 49.
Designate the last 2 digits of the address to
be 17, 33, 49.
Designate the address in increments of the
values of which reminder is 1 when being
devided by 16.
Designate the address in increments of the
values of which reminder is 1 when the last
4 digits are devided by 16.
Designate the system No. (1 digit) + link
register No. (4 digits). The system No. 0 is
only available.
4-63