NAiS GT Series Technical Manual page 83

Setting the communication conditions
Setting communication conditions on the GT side
Set the COM. port communication conditions as follows.
Item
Baud rate
Data length
Parity check
Stop bit
Usable devices
Device type
Input relay (X)
Output relay (Y)
Internal relay (M)
Bit device
State (S)
Timer (contact) (TS)
Counter (contact)
(CS)
Input relay (X)
Output relay (Y)
Internal relay (M)
Word device
State (S)
Timer (current value)
(TN)
Counter (current
value) (CN)
Data register (D)
Note1) The addresses you can use may differ depending on the model. For details, please see the
manual for the PLC you are using.
Note2) If using an input relay, output relay and auxiliary relay in word units, please set the address in 16
point increments from 000. (X000, X020, X040 ..., M000, M016, M032).
Reference: <Chapter 8 Troubleshooting>
Value set
9600 bps
7 bits
Yes, even
1 bit
FX1N range No.
X0000 to X0337
Y0000 to Y0337
M0000 to M1535
S0000 to S0999
TS0000 to TS0255
CS0000 to CS0255
X0000 to Y0320
Y0000 to Y0320
M0000 to M1520
S0000 to S0976
TN0000 to TN0255
CN0000 to CN0255
D0000 to D0999
FX2N range No.
X0000 to X0337
Y0000 to Y0337
M0000 to M1535
S0000 to S0999
TS0000 to TS0255
CS0000 to CS0255
X0000 to X0320
Y0000 to Y0320
M0000 to M1520
S0000 to S0976
TN0000 to TN0255
CN0000 to CN0255
D0000 to D0999
Remarks
Designate the
address in
increments of 20.
Designate the
address in
increments of 20.
Designate the
address in
increments of 16
Designate the
address in
increments of 16.
4-23