24 V/RS232C type (AIGT0030B/AIGT0030H)
Note:
• There is no RS and CS (control lines).
• Make sure that wiring and placement of the cable are performed so that there is no impression of
external noise on the cable and no induction. Also, shielded wiring should be used for cables.
• AIGT0030** conforms to EMC standards EN61000-6-4 and EN61000-6-2 of the European EMC
directive (EMC Directive 89/336/EEC). As conditions, the following is required.
1. Use shielded wire cables (equivalent of AIGT8162).
2.Perform grounding of the cable shield and GT01
24 V/RS422 type (AIGT0032B/AIGT0032H)
Note:
• There is no RS and CS (control lines).
• Make sure that wiring and placement of the cable are performed so that there is no impression of
external noise on the cable and no induction. Also, shielded wiring should be used for cables.
• AIGT0030** conforms to EMC standards EN61000-6-4 and EN61000-6-2 of the European EMC
directive (EMC Directive 89/336/EEC). As conditions, the following is required.
1. Use shielded wire cables (equivalent of AIGT8162).
• 2.Perform grounding of the cable shield and GT01
• "E" is used to set the terminating station.
Reference: <2.2.2 Grounding>
1-17