Accessory Harness - Carefree Compass Installation Manual

C
OMPASS
A H
CCESSORY ARNESS
Some installers may wish to have a single wire entry hole into the vehicle. A special canopy from Carefree
contains an accessory harness at the awning rail that extends the idler speaker wire over to the motor arm.
Accessory
Harness
Trim &
Splice
Speaker
Wire
With Accessory Harness
Speaker
Accessory
Harness
Holder
LED
With Awning Rail LED
When it is necessary to extend the speaker wires use 22 awg, 2-strand, flat wire (wire furnished by installer).
1. On the idler side:
1.1. Route the harness from the canopy into the rear rail.
1.2. Trim and strip the speaker wires and accessory harness. Splice the wires together.
2. On the motor side:
2.1. Route the harness from the canopy into the rear rail.
2.2. For bottom routing: the installer must furnish an extension wire (22 awg, 2-strand, flat wire). This wire is
routed with the existing speaker wire and the LED wires in the back of the rear rail. Refer to page 6.
2.3. Trim and strip the wires from the extension wire and accessory harness. Splice the wires together.
3. Route the speaker wires into the vehicle with the motor and LED wires.
4. Seal the holes and wires with a quality sealant.
10
Installation Manual

Accessory Harness

Along Awning Rail
Speaker Wires
in Arm
Accessory
Harness
Without Awning Rail LED
Led & Accessory
T o p
R o u
Speaker Wires
in Arm
B o t t o
Speaker
t i n g
R o u
Carefree of Colorado
Harnesses
t i n g
Installer
Furnished
Wires
Top of Arm Routing
Accessory
Harness
Installer
Furnished
Wire
m
Led Harness &
5/8" Hole
Speaker Wires
Bottom of Arm Routing
070035-001r1
5/8" Hole
Speaker
Wire
Trim &
Splice
Speaker
Wire
CO014