Optional Led's; Led Power Harness Routing - Carefree ALTITUDE Installation Manual

Carefree of Colorado
O LED'
PTIONAL
LED options available on the Altitude:
1) White LED strip mounted in the roller tube with the power harness routed through the canopy.
2) RGB LED strip mounted in the roller tube with the power harness routed through the canopy.
3) White LED strip mounted at the awning rail (strip holder is sewn to the canopy).
4) RGB LED strip mounted at the awning rail (strip holder is sewn to the canopy).
NOTICES:
a. Do not route the wire over sharp edges or heat sources that can cut or fray the wires or wire
insulation.
b. Damage that is a result of improper routing may void warranty.
LED P H
OWER ARNESS
This information applies to both White and RGB lights.
1. Route the harness through the routing slot of
the rear extrusion.
2. Route the wires into the vehicle:
2.1 With the motor wires as shown; or
2.2 Drill a 1/4" hole into the vehicle and route
the harness into the vehicle.
3. For roller tube LED's:
3.1 Allow a minimum 3" loop between the
canopy and rear channel
4. For awning rail LED's:
4.1 Allow the harness to extend 3" - 4" past the
top of the channel.
4.2 For white LED's:
vehicle connect the power cord to the LED
strip.
070026-001
Installation Manual
S
R
OUTING
On the outside of the
LED Canopy Harness
3" Loop
Motor
Cable
Roller Tube LED Canopy Harness
LED Power Harness
(Extend 3" Past Rail)
Motor
Cable
Awning Rail LED Power Harness
Altitude
Awning Cable Routing Hole or
1/4" Hole (for LED Harness Only)
Routing
Slot
Accessory
Cable
Awning Cable Routing Hole or
1/4" Hole (for LED Harness Only)
Accessory
Cable
Alt009
9