Optional Factory Installed Speakers - Carefree Compass Installation Manual

Carefree of Colorado
O F
PTIONAL ACTORY
The Compass arms can be ordered with factory installed speakers at the arm
elbows. The arms are prewired for the speakers.
The wires can be individually routed into the vehicle at the top or bottom of the
arms.
When it is necessary to extend the speaker wires
use 22 awg, 2-strand, flat wire (wire furnished by
installer).
Top of the Arm Routing:
1. Pull the speaker wire from the back of the
rear rail before mounting the arms.
2. On the idler side, drill a minimum 1/4" hole to
route the wires into the vehicle.
3. On the motor side, route the wires with the
motor cable and LED harness.
Bottom of Arm Routing:
1. Carefully back out the mounting screws on
the arm so that the arm can be pulled away
from the wall (about 1/8").
2. Route a piece of 22 awg, 2-strand, flat wire
(wire furnished by installer) down the back of the
mounting rail in the rear groove. For the motor
side, this would be the same groove as the LED
Harness.
3. Hold the arm in position; make sure that the
wires are not pinched. Tighten the screws
loosened previously.
4. Strip and splice the routed wire with the speaker
wire.
5. On the idler side, drill a minimum 1/4" hole to
route the wires into the vehicle.
6. On the motor side, route the wires with the motor cable and LED harness.
7. Seal the holes and wires with a quality sealant.
070035-001r1
Installation Manual
I S
NSTALLED PEAKERS
1/4" Hole
Trim Wires
Furnished
Idler Arm
Cable Routing at Top of Arm
Speaker
Wire
Cable Routing at Bottom of Arm
& Splice
Installer Speaker
Wire
Wire
1/4" Hole
Compass
Speakers
Motor Arm
5/8" Hole
Speaker
Wire
Trim Wires
& Splice
Installer Speaker
Furnished Wire
Wire
Led Harness &
5/8" Hole
Speaker Wires
CO013
CO012
9