Seeley Breezair EXH Series Installation And Operating Instructions Manual page 8

The high salinity setting is designed to operate
the cooler at a maximum safe salinity level to
maintain a normal working life. It also results in
a minimum usage of water.
ILL1106-A
ILL1110-A
NOTE: High salinity outlet water should not be
used on salt sensitive grass or plants. It has a
high salt content.
The current WaterManager ® setting is
displayed by holding down the E button and
pressing the E button. The setting can be
changed by holding down the _0F27 button and
pressing either the _ or ( -v button for
HI and LO respectively.
The factory default WaterManager ® setting is
H!. For areas operating with bore water, DIP
switch F should be switched to off (see page
6). This will disable the salinity measuring
circuit and simply drain water from the tank
every 65 minutes of operation.
POWER FAILURE RECOVERY
After a power disruption is restored, the cooler
will automatically restart within 10 minutes, if
the remote control has remained "ON" during
the power failure.
BATTERIES
If the batteries are installed when the display is
completely blank, the display will remain blank
for 5 seconds. After 5 seconds the display will
show "ld" for 1 second, then display the clock.
The remote control is now ready to use.
The remote control requires 3 AAA batteries,
The use of good quality alkaline batteries is
recommended, Under normal conditions a set
of batteries will operate for 18 months.
Do not use rechargeable batteries as their
_e rating is too low for the remote control.
When the batteries are getting low on power,
BATTERY LOW is displayed on the screen (the
cooler may also switch off while the display
remains ON). This indicates that the batteries
have only a small amount of life remaining.
To change the batteries remove the cover from
the back of the remote control. Pull out the old
batteries and replace them all with the new
ones. Do not mix new batteries with old
batteries.
The remote control has 2 minutes of back-up
power to retain its memory while the batteries
are being changed.
DIP SWITCHES
There are 2 rows of DIP switches located
under the battery cover on the remote control.
WARNING: Do not alter DiP switches 1 to 8
on top row and 7 & 8 on bottom row as the
cooler will cease to work.
1 2345678
ON
1 2345678
°"I
EXAMPLE ONLY ILL217-H
Definition of DIP switch positions (first 6 in
bottom row only) are as follows:
BOTTOM ROW
(1) ...... Reserved for later use.
(2) ...... OFF, 24 hour clock,
ON, 12 hour clock.
(3) ...... Not Used
(4) ...... OFF, no pre-cool.
ON, pre-cool.
(5) ...... OFf drains 3 days after power off.
ON, drains 3 hours after power off.
(6) ...... OFF, drains every 65 minutes of
operation.
ON, activates water salinity circuit
(WaterManager _ ).