Seeley Breezair EXH Series Installation And Operating Instructions Manual page 7

ECONOMY MODE
Selecting the ECONOMY mode limits the
maximum available cooling or ventilation and
reduces the power used by up to 20%. The
ECONOMY function can be used in either
AUTO or MANUAL modes. To select this mode
press the E button so that ECONOMY
appears on the display.
During this operation the word PRE-COOL will
be displayed on the remote control's screen.
ILL1125-A
DRAIN MODE
Pressing the ( ..... button opens the drain
valve in the cooler and empties the water in the
tank. This will leave the tank clean and dry and
turn the cooler off.
ILL1107-A
If the cooler has not been used for 3 days or 3
hours, depending on the DIP switch setting -
see page 6, the tank will automatically be
drained to ensure the system remains clean.
PRE-COOL MODE
Your remote control is designed to allow for the
saturation of the cooler's cooling pads before
the fan is switched on. This function, referred
to as PRE-COOL mode, is enabled at DIP
switch D (refer to page 6). Once it is enabled
the cooler, when first switched on, will operate
as follows:
(1) ...... If the pan is empty the drain system will
be closed. The pan will then be filled.
(2) ...... The water inlet system allows water to
fill the pan, until the water level reaches the
lower pins of the water probe. After a 30
second delay, the pump will turn on and
saturate the cooling pads.
(3) ...... After the pump has been running for 2
minutes the fan will start.
ILL1142-A
NOTE: PRE-COOL mode will not be activated
if VENT is selected on the remote control or
the cooler is used again shortly after having
been turned off.
WATER MANAGER
The Breezair remote control is fitted with the
WaterManager ® feature which automatically
monitors the quality of the water in the cooler.
The WaterManager ® drains the existing water
in the cooler to allow it to be replaced with
fresh water, only when it is needed. Therefore,
you may notice your cooler draining water
occasionally. How often the WaterManager ®
performs this operation depends upon the
quality of the water supply and the rate of
evaporation.
In areas of poor water quality, the
WaterManager ® will operate more often as it
tries to maintain the optimum water quality in
the cooler. This maximizes the cooling effect
and life of the cooling pads.
The remote control has a unique feature
attached to the WaterManager ® that allows
you to specify either high or low salinity
settings. The low salinity setting is used in
specific circumstances only. We recommend
talking with your dealer before adjusting this
setting.
ILL1111-A