Table of Contents
Advertisement
TIMED
AUTOMATIC
STOP
You can also set the air cooler so that it will
turn off after a set number
of hours.
1.To set a delayed
stop time, press
_
with
the cooler RUNNING.
"Stopping
in" will display.
2.Press
C_
or
_
to adjust the number
of hours
before
the
air cooler
will stop.
The
maximum
delay setting is 24 hours.
3. Press _
again to begin the timed stop.
ILL1119-A
USING
THE COOLER
Now that you have read these instructions,
press the
_
button to turn your air cooler
on. If the air cooler has not operated
for a while
"Preparing
to Start" will flash on the display
(see page 7). The pre cool cycle will begin and
will take only a few minutes
to complete.
After
this time, the fan will start automatically,
and
you can enjoy the comfort
of cool fresh air!
AiR
TOO
COLD
With the cooler running
in Automatic
mode, you
may find that you are too cold or that the air
cooler is blowing
too much air. Press
to reduce the amount
of cooling.
If you are too cold with the cooler running
in
Manual
mode, then press
C_
to reduce the
fan speed. You can also circulate
fresh
uncooled
air by pressing
_co_
until "Vent"
displays.
AiR
NOT COLD
ENOUGH
You may find that with the air cooler running
in
Automatic
mode, you are not cool enough.
Simply press C_
to increase
cooling.
If you are not cool enough with the air cooler
running
in Manual
mode, then press
to increase
the fan speed.
Ensure that cooled
air is circulating
by pressing
_o_
until "Cool"
displays.
You can experiment
with the settings
on
your wall control.
This is the best way to
decide what suits your needs.
DRAIN
VALVE
This air cooler is supplied
with an automatic
drain that performs
two primary functions:
1. It opens and closes
automatically
to control
salt concentrations
in the tank.
2. It opens to drain all water and keep your
tank dry during prolonged
"off" cycles.
Your cooler will automatically
change
some of
the water during operation
when the water
salinity
becomes
too high. This ensures
the
water is always
fresh and helps maintain
your
cooler
in good condition
to ensure
optimum
cooling
performance.
This is called "salinity
sensor"
method.
Alternatively
and if necessary,
the air cooler can be set to change
some water
after a set time of cooling operation.
The
frequency
of the automatic
drain function
may
have been adjusted
by your installer.
This is
called "timed drain" method.
You can select either method of water
replacement
with the following
steps.
1 .When the cooler is OF__E_F
press and hold
2.While
still pressing
-_,
press _.
3. A number
will display which corresponds
to
the selected
salinity
control method as shown
in the table below.
Press C_
or C_
to change
the
displayed
number
to the desired
salinity
control
method.
4.Press
_
to set your selection.
Display Number
Salinity Control
Method
01
Timed Drain
When the air cooler is not operated
for 72
hours, the drain valve will open automatically
to empty all water from the cooler.
If
necessary,
you can adjust this delay time with
the following
steps.
1 .When the cooler is off, press and hold i_.
2.While
still pressing
C_,
press
_-E_.
3.A number
will display indicating
the current
water drain delay time according
to the table.
Hide quick links:
Advertisement
Table of Contents
