Stop-Accounting-Buffer Enable - H3C S5510 Series Command Manual

Command Manual – AAA&RADIUS&HWTACACS
H3C S3610&S5510 Series Ethernet Switches
Note that:
You are not allowed to assign the same IP address to both primary and secondary
authorization servers.
If you repeatedly use this command, the latest configuration overwrites the
previous one.
You can remove an authorization server only when it is not being used by any
active TCP connections.
Related command: display hwtacacs.
Example
# Configure the secondary authorization server.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary authorization 10.163.155.13 49

1.3.17 stop-accounting-buffer enable

Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
HWTACACS scheme view
Parameter
None
Description
Use the stop-accounting-buffer enable command to enable the switch to buffer the
stop-accounting requests that bring no response.
Use the undo stop-accounting-buffer enable command to disable the switch from
buffering the stop-accounting requests that bring no response.
By default, the switch is enabled to buffer the stop-accounting requests that bring no
response.
Stop-accounting requests are critical to billing and will eventually affect the charges;
they are important for both the users and the ISP. Therefore, the switch should do its
best to transmit them to the RADIUS server. If the RADIUS accounting server does not
respond to such a request, the switch should first buffer the request on itself, and then
retransmit the request to the RADIUS accounting server until it gets a response, or the
Chapter 1 AAA & RADIUS & HWTACACS
1-76
Configuration Commands