Clock Stop Warm-Up - H3C S9500 Series Command Manual

Command Manual – Clock Monitoring
H3C S9500 Series Routing Switches
Use the undo clock ssmcontrol command to restore the default.
By default, SSM level is deactivated.
Note that:
When SSM level is activated, the SSM level becomes the decisive factor in
reference source automatic selection.
When SSM level is not activated, you can still set and view the SSM levels, but
they are ignored in reference source automatic selection are decided by reference
source priority.
Examples
# Activate SSM of clock monitoring module.
<Sysname> system-view
[Sysname] clock ssmcontrol on

1.1.8 clock stop warm-up

Syntax
clock stop warm-up
View
System view
Default Level
2: System level
Parameters
None
Description
Use the clock stop warm-up command to manually stop the clock monitoring module
from warming up and enable it to work normally.
Examples
# Manually stop the clock monitoring module from warming up and enable it to work
normally.
<Sysname> system-view
[Sysname] clock stop warm-up
Chapter 1 Clock Monitoring Configuration
1-7
Commands