Radius Trap - H3C S5510 Series Command Manual

Command Manual – AAA&RADIUS&HWTACACS
H3C S3610&S5510 Series Ethernet Switches
The undo radius scheme command cannot be used to delete the default
RADIUS scheme. In addition, you cannot delete a RADIUS scheme which is being
used by an online user.
Related command: key, retry realtime-accounting, timer realtime-accounting,
stop-accounting-buffer enable, retry stop-accounting, server-type, state,
user-name-format, retry, display radius and display radius statistics.
Example
# Create a RADIUS scheme named radius1 and enter its view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1]

1.2.15 radius trap

Syntax
radius trap { accounting-server-down | authentication-server-down }
undo radius trap { accounting-server-down | authentication-server-down }
View
System view
Parameter
accounting-server-down: Enables sending traps when the RADIUS accounting
server gives no response.
authentication-server-down:
authentication server gives no response.
Description
Use the radius trap command to enable the RADIUS trap function.
Use the undo radius trap command to disable the RADIUS trap function.
By default, RADIUS trap is disabled.
After the RADIUS trap function is enabled, the following happens. If the RADIUS server
does not respond to the accounting or authentication request packets from an NAS, the
NAS retransmits accounting or authentication request packets to the server. When the
number of packet transmissions from the NAS to the server reaches one half of the
maximum transmission number, the system sends a trap message once; when this
number reaches the maximum, the system sends a trap message once again.
Chapter 1 AAA & RADIUS & HWTACACS
Enables sending
1-46
Configuration Commands
traps when the RADIUS