State - H3C S5510 Series Command Manual

Command Manual – AAA&RADIUS&HWTACACS
H3C S3610&S5510 Series Ethernet Switches
Use the undo server-type command to restore the default RADIUS server type
supported by the switch.
By default, the switch supports the standard type of RADIUS server. The type of
RADIUS server in the default RADIUS scheme "system" is extended.
Related command: radius scheme.
Example
# Set the RADIUS server type in RADIUS scheme radius1 to extended.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] server-type extended

1.2.25 state

Syntax
state { primary | secondary } { accounting | authentication } { block | active }
View
RADIUS scheme view
Parameter
primary: Specifies the server to be set is a primary RADIUS server.
secondary: Specifies the server to be set is a secondary RADIUS server.
accounting: Specifies the server to be set is a RADIUS accounting server.
authentication:
authentication/authorization server.
block: Sets the status of the specified RADIUS server to block (that is, the down state).
active: Sets the status of the specified RADIUS server to active (that is, the normal
working state).
Description
Use the state command to set the status of a RADIUS server.
By default, all the RADIUS servers in a user-defined RADIUS scheme are in the active
state;
For the primary and secondary servers (authentication/authorization servers, or
accounting servers) in a RADIUS scheme, note that:
Specifies the server
1-55
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
to be set is a RADIUS