Reinstallation Of Cleaned Parts - Bartscher 900004 Instruction Manual

6.2.7 Reinstallation of cleaned parts

All cleaned and disinfected parts should be carefully assembled and reinstalled to the
device. Follow the instructions below for the individual parts.
Container assembly and installation
WARNING!
Before reinstalling the container on the device make sure that seal is correctly
installed, otherwise the liquid may escape and cause burns!

Fig. 31 shows correctly installed seal
which uniformly adheres to the whole
edge of the container.
 Moisten the seal with water, replace the
container and press it down.
Do not use grease or vaseline!

Fig. 34 shows correctly replaced
container which uniformly adheres to
the whole edge of the bottom.
- 46 -
Fig. 31
Fig. 34

Fig. 32 shows incorrectly installed
seal; in such case the seal DOES
NOT adhere to the whole edge of the
container.

Fig. 35 shows incorrectly replaced
container; in such case the container
DOES NOT adhere to the whole
edge of the bottom.
Fig. 32
Fig. 33
Fig. 35