Warm-Up Checklist (4.Is) - Arrow PA-28R-201 Pilot's Operating Handbook And Faa Approved Airplane Flight Manual

SECTION 4
NORMAL PROCEDURES
PIPER AIRCRAFT CORPORATION
PA-28R-201, ARROW
4.5c Engine Start Checklist (4.13) (continued)
ENGINE START WITH EXTERNAL POWER SOURCE (4.13d) (
(continued)
Terminals ....................................... CONNECT
External Power Plug .................... INSERT in receptacle
Proceed with normal start.
Throttle .......................... LOWEST POSSIBLE RPM
External Power Plug ................ REMOVE from receptacle
BATT MASTR Switch .................................. ON
ALTR Switch ..................... ON - CHECK AMMETER
Oil Pressure ........................................ CHECK
CAUTION
It is possible to use the ship's battery in parallel
by turning only the battery master switch ON.
This will give longer cranking capabilities, but
will not increase the amperage. Care should be
exercised because if the ship's battery has been
depleted, the external power supply can be
reduced to the level of the ship's battery. This
can be tested by turning only the battery master
switch ON momentarily while the starter is
engaged. If cranking speed increases, the ship's
battery is at a higher level than the external
power supply.
NOTE
For all normal operations using the PEP
jumper cables, the battery master and
alternator switches should be OFF.
4.5d Warm-Up Checklist (4.15)
WARM-UP (4.15)
Throttle ...................................
1400
to
1500
RPM
REPORT: V8-1365
4·8
ISSUED: SEPTEMBER 15, 1988
(
(