Arrow PA-28R-201 Pilot's Operating Handbook And Faa Approved Airplane Flight Manual page 250

SECTION 9
SUPPLEMENT 6
PIPER AIRCRAFT CORPORATION
PA-28R-201, ARROW
(3) Heading Selector Knob - ROTATE BUG to the
ILS front course inbound heading.
NOTE
When BC is selected, the lateral operating
mode will change from HDG (if selected) to
wings level for 5 seconds. A 45° intercept angle
will then be established based on the position of
the bug.
(a) If the D-Bar is greater than 2 to 3 dots: the
autopilot will annunciate HDG (unless HDG not
selected) and BC modes with APR flashing; when
the computed capture point is reached the H DG
annunciator will go out, the BC and APR annun-
ciators will illuminate steady and the selected
course will be a utoma tically
ca
ptu red a nd tracked.
(
(b) If the D-Bar is less than 2 to 3 dots: the HDG
mode will disengage upon selecting BC mode; the
BC and APR annunciators will illuminate steady
and the capture /track sequence will automatically (
begin.
7.
Missed Approach
a. Autopilot - DISENGAGE by pressing the AP ENG
button or the optional AP DISC/TRIM INTER switch.
b. MISSED APPROACH - EXECUTE.
c. AP ENG Button - PRESS (if AP operation is desired).
Note AP annunciator ON.
8. Before Landing
a. Autopilot - DISENGAGE by pressing the AP ENG
button or the optional AP DISC/TRIM INTER switch.
SECTION 5 - PERFORMANCE
No change.
SECTION 6 - WEIGHT AND BALANCE
Factory installed optional equipment is included in the licensed weight
and balance data in Section 6 of the Basic Pilot's Operating Handbook.
REPORT: V8-1365
ISSUED: SEPTEMBER 15, 1988
9-42, 8 of 20
(