Table of Contents
Advertisement
PIPER AIRCRAFT CORPORATION
PA-28R-201, ARROW
CAUTION
SECTION 9
SUPPLEMENT 5
When installed, an RMI will continue to
display the bearing to the VOR station; it will
not display bearing to the RNA V waypoint.
Soon after being on course direct to waypoint 1, ground speed and
TIS will become accurate.
At this point you may also want to check the ident of the VOR by
pulling the
ONI OFFI
Volume switch to place it in the OUT posi-
tion. When satisfied, return the switch to the IN position to mute
the ident tones.
(d) Change Over to Waypoint 2
Depress the DSP button and the number 2 will appear (blinking)
over the DSP annunciation and the waypoint 2 frequency will
appear in the data display. The DME display will not change
because waypoint 1 data is still "in use". At this point, if desired,
waypoint 2 radial and distance data may be rechecked by depressing
the DATA button for each.
I
When satisfied, depress the USE button to put waypoint 2 data
"in use". The number 2 will appear in the USE annunciated space;
the number 2 in the DSP space will stop blinking. Waypoint 2
frequency will automatically appear.
Following VORl DME receiver acquisition of the new VORTAC
frequency, distance display will begin reading distance (NM),
ground speed (KT) and TTS (MIN) to waypoint 2. The CDI
TOI
FROM flag will move to the TO position and continue flying
course directly to waypoint 2. -
(e) Flying Direct to a VORIDME Facility
(1) Depress the VOR button and RNV IENR will disappear from
the mode annunciator and VOR will appear. The distance
display will change to show distance to the VORTAC instead
of to the waypoint. Ground speed (KTS) and time-to-station
(MIN) displays will also change accordingly.
ISSUED: SEPTEMBER 15, 1988
REVISED: MAY 8, 1995
REPORT: VB-1365
50f14 9-25
Advertisement
Chapters
Table of Contents
