Emergency Landing Gear Extension (3.31) - Arrow PA-28R-201 Pilot's Operating Handbook And Faa Approved Airplane Flight Manual

SECTION 3
EMERGENCY PROCEDURES
PIPER AIRCRAFT CORPORATION
PA-28R-201, ARROW
3.5k PROPELLER OVERSPEED (continued)
Propeller Control ..................................................... FULL DECREASE ('
rpm, then set if any
control available.
Airspeed .................................................................................. REDUCE
Throttle .................................................................... AS REQUIRED to
remain below 2700 rpm
3.5m EMERGENCY LANDING GEAR EXTENSION (3.31)
NOTE
Refer to paragraph 4.39 for differences when
emergency gear extension is being performed for
training purposes.
Prior to emergency extension procedure:
BAIT MASTR Switch ....................................................... CHECK ON
ALTR Switch ...................................................................... CHECK ON
Circuit Breakers ........................................................................ CHECK
NAV LIGHT Switch ................................................... OFF (in daytime) (
Gear Indicator Bulbs ................................................................. CHECK
Iflanding gear does not check down and locked:
Airspeed ................................................................... REDUCE BELOW
87 KIAS
Landing Gear Selector Switch ........................................ GEAR DOWN
POSITION
If
gear has still failed to lock down, move and
hold
the emergency
lever down to the Emergency Down position.
If gear has still failed to lock
down~
yaw the airplane abruptly from
side to side with the rudder.
If the nose gear will not lock down using the above procedure, slow
the aircraft to the lowest safe speed attainable using the lowest power
setting required for safe operation and accomplish the following:
Landing Gear Selector Switch ........................................ GEAR DOWN (
POSITION
If landing gear does not check down, recycle gear through up position
and then select gear DOWN.
REPORT: VB-1365
3-8
ISSUED: SEPTEMBER 15, 1988
REVISED: MAY 8, 1995