Arrow PA-28R-201 Pilot's Operating Handbook And Faa Approved Airplane Flight Manual page 231

PIPER AIRCRAFT CORPORATION
PA-28R-201, ARROW
ENROUTE NAVIGATION
(a) Load Waypoint 1 Data
SECTION 9
SUPPLEMENT 5
(I) Put waypoint 1 in the DSP window by depressing the DSP
button. (If there is a 2 in the DSP window initially. push the
DSP button three times to go through the 2-3-4-1 sequence
to reach
I.)
The previously selected frequency (stored in memory) for
waypoint I will be displayed and "I" will be flashing unless
USE and DSP are the same.
(2) . Select a waypoint 1 frequency using the data input controls
which are the two concentric knobs on the right. The smaller
of the 2 knobs controls the .1 MHz and .05 MHz digits. The
outer knob changes the 1 MHz and IOMH7. displays. The
selected frequency will appear in the display and be placed in
memory.
(3) Select a waypoint I radial by first depressing the DATA button.
This will cause the radial for the previous waypoint I to appear
in the data display over the annunciation RAD. Select the
radial with the data input controls. The outer knob controls the
10° and 100° digits; the center knob IN position controls the
1° and the center knob OUT position controls the 0.1° digit.
The selected radial will appear in the display and be placed in
memory.
(4) Select a waypoint I distance by again depressing the DATA
button, causing display of the previous waypoint 1 distance in
the data display over the annunciation DST. Select the distance
with the data input controls. The outer knob controls the
10 NM digit, the center knob IN position controls the I NM
digit, and the center knob OUT position controls the 0.1 NM
digit. The selected distance will appear in the display and be
placed in memory.
ISSUED: SEPTEMBER 15,1988 REPORT: VB-1365
3
of
14, 9-23