Raising The Mower Decks To The Transport Position; Adjusting The Height-Of-Cut - Toro Groundsmaster 1200 Series Operator's Manual

Raising the Mower Decks
to the Transport Position
For instruction on using the PTO and rear attachment
control, refer to the Operator's Manual for your tow
vehicle.
1. Move the mower to a flat area.
2. Shut off the PTO.
3. Pull and hold the deck-lock rope
Figure 38
1. Deck-lock rope
2. Hose guide
4. Move the control for the rear attachment-circuit
to the R position.
AISE
The mower decks raise to the
position (Figure 39).
Figure 39
5. When the decks fully raised, release the rope
and attachment control.
(Figure 38).
g250665
3. Lock arm
TRANSPORT
g250706
The deck locks engage the deck pins
40).
1. Right deck lock
6. Move the control for the rear attachment-circuit
to the
LOWER
support the weight of the decks.

Adjusting the Height-of-Cut

1. If the mower is installed to the tow vehicle,
perform the following:
A. Ensure that the PTO is disengaged.
B. If the mower decks are in the transport
position, lower the decks; refer to
the Mower Decks from the Transport
Position (page
C. Engage the parking brake, shut off the
engine, remove the key, and wait for all
moving parts to stop.
2. Determine the height that you want to cut the
grass.
3. Loosen the 4 locknuts that secure the 4
height-of-cut adjusters
deck.
24
Figure 40
2. Center deck lock
position until the deck locks
22).
(Figure 41) of the mower
(Figure
g250714
Lowering