Assembling The Pto-Drive Shaft - Toro Groundsmaster 1200 Series Operator's Manual

6
Assembling the PTO-Drive
Shaft
Parts needed for this procedure:
1 PTO-drive shaft half (forward)
Procedure
1. Align the inner tube of the rear PTO-drive shaft
half with the outer tube of the forward PTO-drive
shaft half, and slip the tubes together
Important:
The ends of the inner and outer
PTO-drive shaft tubes assemble only 1
way—do not force them together.
1. Rear PTO-drive shaft half
2. Forward PTO-drive shaft
half
2. Move the PTO-drive shaft onto the drive-shaft
rest of the hose guide
(Figure
Figure 8
3. Inner tube
4. Outer tube
(Figure 9).
1. Drive-shaft rest (hose
guide)
3. Partially extend the PTO drive shaft to access
the grease fitting near the middle of the inboard
drive-shaft guard
8).
4. Apply grease to the grease fitting for the
telescoping drive-shaft joint as shown in
10.
g270859
9
Figure 9
2. PTO-drive shaft
(Figure 10).
Figure 10
g270860
g264298
Figure