Toro Groundsmaster 1200 Series Operator's Manual page 42

Figure 80
1. Height-of-cut adjuster
2. Center mower blade
2. Measure the distance between top of adjuster
block to the ground
Rotate the height-of-cut adjuster until you
achieve the following results:
•
The height-of-cut block to the ground
measurement the same at all 4 locations.
•
The wood block is a slip fit between the
center mower blade and the ground.
Figure 81
1. Top of the height-of-cut adjuster
3. Loosen the 2 socket-head screws that secure
the pointer to the height-of-cut adjuster block,
align the pointer to the 2 inch mark on the decal,
and tighten the screws
3. Wood spacer block 51 mm
(2 inches)
4. Rear flap
(Figure 81).
(Figure 82).
g256063
1. Height-of-cut adjuster
2. Socket-head screw
3. Nut
4. Repeat step
adjusters.
5. At the rear roller, raise the left and right height
of cut adjusters to the 2-1/4 inch mark on the
decal (Figure
1. 2-1/4 inch mark (decal)
2. Pointer
g256087
6. Loosen the socket-head screws that secure the
2 pointers to the height-of-cut adjuster block,
align the pointers to the 2 inch mark on the
decal, and tighten the screws
42
Figure 82
4. Pointer
5. 2 inch mark (decal)
3 at the other height-of-cut
83).
Figure 83
3. Height-of-cut adjuster
(rear roller)
(Figure
g256085
g256086
84).