Troubleshooting Guide - Intex Hydro Flow Swim Trainer SM24100 Owner's Manual

TROUBLESHOOTING GUIDE (continued)
PROBLEM
Mounting bracket
●
can't be assembled
with the in ground
●
pool
Swim-trainer unit is
●
not horizontal with
●
the water surface
Swim-trainer unit will hibernate
No output from the ●
if no operating more than 1 hour.
transformer
The transformer fuse broken.
●
Motor too hot and overload protection is
●
shut off.
The transformer is unplugged or off.
No LED display
●
The transformer is not connected with
●
swim-trainer unit.
Display panel cord is loose.
●
Display panel failure.
●
Emergency stop lanyard is put wrong
●
place.
Abnormal display /
●
buttons not working
●
Too noisy / Jet water Swim-trainer unit is not fully
●
is weak or shaking immersed in the water.
●
Swim-trainer unit components
●
not securely connected or in place.
Remote Control out The battery is on low power.
●
of control
SAVE THESE INSTRUCTIONS
(303IO) MODEL SM24100 SWIMMING MACHINE ENGLISH 7.5" X 10.3" PANTONE 295U 08/30/2018
CAUSE
The ground is not concrete, i.e., it is
asphalt, lawn or earth.
The screws are not fully inserted in the
drill holes.
The support bracket is not opened.
Adjust the support nuts on the
swim-trainer unit.
Display panel cord is loose.
Display panel failure.
The motor impeller is broken.
English
SOLUTION
Assembly the mounting bracket
●
on the cement ground.
Check and tighten the screws
●
securely.
Open and adjust the support
●
bracket. See "Setup Instructions".
Adjust the support nuts on the
●
swim-trainer unit.
Turn off the transformer, waiting
●
2 minutes then turn on agin.
Replace the transformer fuse.
●
Let the motor cool down and
●
restart again.
Ensure the transformer is
●
plugged and switched on.
Connect the transformer with
●
swim-trainer unit.
Ensure that the display cord is
●
plugged fi rmly into the cell
housing receptacle.
Contact Intex Service Center.
●
Put the emergency stop lanyard
●
on correct place. See "Setup
Instructions".
Ensure the display cable is
●
plugged fi rmly into the display
panel receptacle.
Contact Intex Service Center.
●
Make sure the device is under
●
the water.
Turn off and replace the motor
●
impeller.
Check all components, especially
●
the support bracket. See "Setup
Instructions".
Replace the remote control
●
battery.
See "Operating Installations".
Page 19
303A