Troubleshooting Guide - Intex Hydro Flow Swim Trainer SM24100 Owner's Manual

TROUBLESHOOTING GUIDE

LED PANEL
CODE
The maximum operating time
●
(90 minutes) has fi nished under the
E
same set mode.
Low water level.
●
Swim-trainer unit is not fully immersed
●
in the water.
C Remote control is in an emergency cut
●
off situation.
Household voltage is too low.
●
Household voltage is too heigh.
●
Clogged motor impeller
●
H
Water temperature is around
●
35°C (95°F)
L
Operating time is too long
●
Water temperature is around
●
35°C (95°F)
P
SAVE THESE INSTRUCTIONS
(303IO) MODEL SM24100 SWIMMING MACHINE ENGLISH 7.5" X 10.3" PANTONE 295U 08/30/2018
PROBLEM
English
SOLUTION
It's normal. Turn off and unplug the unit.
●
Then plug the RCD/GFCI back and
restart all back again.
Fill the pool with water up to correct
●
water level (see pool owner's manual).
Make sure the device is under the water.
●
It's normal. Turn off the transformer for
●
1 minute, then plug in.
Check the voltage is within the range
●
stated on the device housing.
Check the voltage is within the range
●
stated on the device housing
Turn off the power, check and clean the
●
motor impeller
Turn off and unplug the unit. When the
●
water has cooled down, plug the RCD/
GFCI back and restart all over again.
Turn off and unplug the unit, after
●
30 minutes later plug the RCD/GFCI
back and restart all over again.
Turn off and unplug the unit. When the
●
water has cooled down, plug the RCD/
GFCI back and restart all over again.
303A
Page 18