Switching The Monitor To Standby; After Monitoring; Disconnecting From Power - Philips Avalon FM20 Instructions For Use Manual

3 Basic Operation

Switching the Monitor to Standby

To switch the monitor to Standby:
Either
Select the
Or
Enter the
1
Select
2
Pressing any key or selecting any field on the screen will resume monitoring.

After Monitoring

Discharge the patient.
1
2 Remove the transducer from the patient and, using a soft tissue, remove any gel from it. Then
clean the transducer.
Tear off the paper at the fold. To avoid misalignment of the recorder mechanism, NEVER pull on
3
the paper to advance it, or try to tear it other than at a fold (unless using the paper guide with the
FM40/FM50).
4 Switch off the monitor.

Disconnecting from Power

FM20/30 To disconnect the monitor from AC power, switch the monitor off using the On/Off switch located
on the right side of the device, or unplug the power cord from the AC mains socket.
FM20/30 To disconnect from Battery power, switch the monitor off using the On/Standby switch located on
the right side of the device.
(with
Battery
Option)
FM40/50 The On/Standby switch does not disconnect the monitor from the AC power source. To disconnect,
unplug the power cord from the AC mains socket. Note that if the power cord is unplugged from the
and FM20/
AC mains socket before the monitor is put into Standby, a beeper is activated. The beeper warns you if
30 with
the monitor is accidentally disconnected from AC mains.
Battery
Option
54
Monitor Standby
SmartKey
Main Setup
menu using the SmartKey
Monitor Standby
.
.
.