Air Filter Maintenance; Separator Replacment - Sullair 10B Series Operator's Manual

Section 6
MAINTENANCE
Figure 6 ---2 Air Filter Element Replacement
(P/N 410036)
* Replacement Element P/N 042445

AIR FILTER MAINTENANCE

Refer t o Figure 6 ---
nance should be performed under any of the fol-
lowing conditions, whichever comes first:
1. As indicated by the filter maintenance indicator.
2. Every 6 months.
Below you will find procedures on how to replace
the air filter element.
AIR FILTER ELEMENT REPLACEMENT
1. Clean exterior of air filter housing.
2. Remove the air filter cover by loosening the
wingnut securing the cover.
3. Remove element and clean interior of housing
using a damp cloth. DO NOT blow dirt out with
compressed air.
4. At this time clean or replace the element.
5. Replace cover.
6. Reset the filter maintenance indicator.
ELEMENT INSPECTION
1. Place a bright light inside the element to inspect
for damage or leak holes. Concentrated light will
24
2. A ir filt e r (P/ N 410036) ma in t e -
shine through the element and disclose any
holes.
2. Inspect all gaskets and gasket contact surfaces
of the housing. Should faulty gaskets be evi-
dent, correct the condition immediately.
3. If the clean element is to be stored for later use, it
must be stored in a clean container.
4. After the element has been installed, inspect and
tighten all air inlet connections prior to resuming
operation.
SEPARATOR REPLACEMENT
Refer t o Figure 6 --- 3. The s eparator must be
changed when indicated by the maintenance
gauge, or once a year whichever occurs first. Order
separator element repair kit number 250034---112
for 25 and 30HP compressors and repair kit num-
ber 250034---114 for 40HP compressors. Follow
the procedure explained below for separator ele-
ment replacement.
Figure 6 ---3 Separator Element Maintenance
*
*
* Repair Kit P/N 250034---112 (25&30HP) and
250034---114 (40HP)