POWER AND CONTROL WIRING
The combined power and control cord (roughly five feet, 1.5m in length) enters the casing
via a water-tight gland on the underside of the fixture. The cord is supplied with a bare tail.
POWER
The power requirements are as follows:
• Voltage:
100-240VAC 50/60Hz
• Power:
13W steady state
The power cord color designations are as follows:
[ E a
l o w
Y e l
e n /
G r e
B r o
G l o
IN-RUSH CURRENT
Although LED fixtures are low power devices compared to their incandescent equivalents,
their power supplies exhibit a trait known as 'in-rush current' when they are first powered
on. This is caused by the various components within the switching power supplies topping
themselves up with power. The in-rush current period lasts only milliseconds and does not
cause any effect when a handful of units are powered on at the exact same time. However,
if many fixtures are linked to the same power input, they will momentarily pull a current that
may greatly exceed their normal operating level. This may affect over-current trips when
power is applied. For this reason it is advisable to limit the number of fixtures on any one
power input.
]
r t h
e ]
[ L i v
w n
r a l ]
e u t
k [ N
u n d
l a c
G r o
s s B
M X
k [ D
l a c
y [ I
t t B
G r a
M a
www.acclaimlighting.com
]
– ]
M X
N D
]
X +
D M
[ I N
M X
R e d
T D
[ O U
e n
G r e
[ O U
i t e
W h
– ]
+ ]
M X
T D
11