Epson SC-F6300 Operator's Manual page 24

SC-F6300 Series Operator's Guide
G
Shake the new ink pack for 5 seconds 15 times
horizontally in approximately 5 cm movements
as shown in the illustration.
H
Check that no warnings or errors are displayed
on the control panel screen before opening the
inlet cover of the slider.
If an error or a warning is displayed, follow the
messages to resolve the error or warning, and
then proceed with the following operation.
I
Remove the ink inlet cap from the ink tank.
The method for removing the ink inlet cap
differs depending on the type of ink being
refilled.
c
Important:
Remove the ink inlet cap slowly. If you
remove the cap too quickly, ink may splatter.
Maintenance
Except for High Density Black ink
For High Density Black ink
(1) Hold the part shown in the circled area in
the illustration to remove the ink inlet cap. If
the ink inlet cap is removed with any other
part, ink adheres.
24