Replacing Paper - Epson SC-F6300 Operator's Manual

SC-F6300 Series Operator's Guide
Making Paper Settings U User's Guide
(Online Manual)
To print at current settings
Press the d/u buttons to highlight Keep
Settings Above and press the Z button.
Proceed to Step 6.
To change settings
Press the d/u buttons to highlight Change
Settings and press the Z button.
B
Highlight a setting you wish to change and
press the Z button.
C
Highlight an option and press the Z button.
D
Press the y button to return to the dialog
shown in Step 2.
E
When settings are complete, highlight Exit and
press the Z button.
F
If ON is selected for Remaining Setup, you will
be prompted to enter the length of the roll.
Press the d/u buttons to choose a value
between 5.0 and 999.5m and press the Z
button. Paper length is set in increments of 0.5
m.
After a short pause the printer will show Ready,
indicating that it is ready to print. Transmit the data
to be printed from a computer.
Basic Operations

Replacing Paper

This section describes how to replace paper. The
procedure is displayed on the control panel screen.
Follow these instructions.
Buttons that are used in the following settings
A
Confirm that the printer is ready and press the
( button.
The Load/Remove Paper menu will be displayed.
B
Press the d/u buttons to select roll paper, and
then press the Z button.
Note:
To perform Roll Paper Remaining, you must
enter the length of the roll paper when the roll
paper is set. In order to perform accurate
remaining roll paper management, we
recommend opening the . tab and recording the
amount of roll paper remaining when you replace
the roll paper.
C
The roll rewinds automatically.
Note:
When the display shows Turn roll paper adapter
to wind up roll paper, rewind the paper by hand.
D
Follow the on-screen instructions to load the
roll paper for the next job.
13