Navigation Overview; Operating Mode - ABB Navigator 500 Series Operating Instructions Manual

Navigator 500
Sodium analyzer

6.4 Navigation overview

Operator
Page 1
Diagnostics
View
Calibration
Log
Fig. 6.3 Menu navigation

6.5 Operating mode

In operating mode, values from connected wet-sections are displayed on Operator Pages. A maximum of 5 Operator Pages can be
displayed.
Operator Page 1 (the default page) displays values from all connected wet-sections simultaneously (a maximum of 4 wet-sections
can be connected). The remaining Operator Pages can be assigned to display values from individual wet-sections (in any wet-section
order). To achieve this, each wet-section must be associated with a template in the Configuration level / Display / Operator Templates
parameters – see page 50.
In Fig. 6.4, Operator Page 1 shows that 4 wet-sections are connected.
Instrument tag
(user-assignable)
Wet-section tag
(user-assignable)
Autoscroll icon –
scrolls each page
sequentially when enabled
Display icon –
see Section 6.10, page 40
*The highest priority diagnostic or alarm is displayed. Other active diagnostic / alarm states can be viewed on the Diagnostics
View – see page 33.
Fig. 6.4 Operator Page 1 (sodium multiple wet-section)
OI/ASO550–EN Rev. G
Operator
Page 2
Signals
View
Alarm
Log
Navigator
TAG 1
2.77 2.77
ppb
No UNa Na
TAG 3
6.93 6.93
ppb
Na
In Configuration
NAMUR (NE107) Status Icons
Failure High Process Alarm
Maintenance Low Process Alarm
Out of Spec High Latch Alarm
Check Function Low Latch Alarm
Operator Operator
Page 3 Page 4
Chart Alarms
View View
Audit Diagnostic
Log Log
2012–04–15
10 : 29: 17
TAG 2
4.28 4.28
ppb
Na
8.82 8.82
ppb
Na
CAL
Diagnostic message or alarm tag –
see Appendix A, page 72 for diagnostic messages
6 Operation overview – transmitter
Operator
Page 5
Outputs
View
Time and date
Process value (PV)
Parameter ID
Unit of measure
Display icon –
see Section 6.10, page 40
31