NETGEAR WAC540 Mount Manual

NETGEAR WAC540 Mount Manual

Ceiling and wall-mount guide
Hide thumbs Also See for WAC540:

Advertisement

Ceiling and Wall-Mount Guide
NETGEAR Insight Managed
Smart Cloud Wireless Access Point (WAC540)
AC3000 802.11ac Wave 2 Tri Radio

Ceiling and Wall-Mount Kit Contents

Mounting plate
3 tall screws and anchors
for wall mounting
Metal bracket with
T-bar, lock screw,
and 4 short screws

Mount the Access Point on a Drop Ceiling

Before mounting the access point, first set up and test the access point to verify
WiFi network connectivity.
Note:
If you are mounting the access point on a hard ceiling, use the wall
mounting instructions on the other side of this document.
1. Slide the T-bar partially into the metal bracket.
2. Attach the metal bracket to the ceiling bar.
3. Push the T-bar over the ceiling bar.
4. Use the lock screw to lock the metal
bracket into place.
5. Use the four short screws to attach
the mounting plate to the T-bar.
6. Hold the access point upside down and attach it to the mounting plate.
7. Twist the access point clockwise to lock it onto the mounting plate.
8. Cable the access point to your network.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WAC540 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for NETGEAR WAC540

  • Page 1 NETGEAR Insight Managed 3. Push the T-bar over the ceiling bar. 4. Use the lock screw to lock the metal Smart Cloud Wireless Access Point (WAC540) bracket into place. 7. Twist the access point clockwise to lock it onto the mounting plate.
  • Page 2 Mount the Access Point on a Wall Support 1. Place the mounting plate on the wall. Thank you for purchasing this NETGEAR product. You can visit www.netgear.com/support to register your product, get help, access the latest 2. Mark the wall where the mounting holes are.

Table of Contents