View Unknown And Known Neighbor Access Points - NETGEAR WAC510 User Manual

Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
- Serial Number. The serial number of the access point.
-
Current Time. The current system time of the access point.
- Uptime. The time since the access point was last restarted.
• AP Interface Status. A green icon indicates that the interface is in use. A gray
icon indicates that the interface is not in use.
• IPv4 Settings section. The following settings are displayed:
- IPv4 Address. The IPv4 address of the access point.
- Subnet Mask. The subnet mask of the access point.
- Default Gateway. The default gateway for the access point.
- DHCP Client. The status of DHCP client (Enabled or Disabled).
• Wireless Settings section. The following settings are displayed, with separate
columns for the 2.4 GHz and 5 GHz radios:
- Wireless Mode. The operating WiFi mode of the radio.
- Channel / Frequency. The channel and frequency that are used by the radio.
View unknown and known neighbor access
points
If you enabled neighbor access point (AP) detection (see Manage neighbor AP detection
on page 120), you can view the unknown access points in the Unknown AP list and the
known access points in the Known AP list.
To view the detected neighbor access points:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 41.
3. Enter the access point user name and password.
Monitor the Access Point and the
Network
195 User Manual