Enable Or Disable Upnp - NETGEAR WAC510 User Manual

Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4. Select Management > Configuration > System > Advanced > Ethernet LLDP.
The Ethernet LLDP page displays.
5. Select one of the following radio buttons:
• Enable. LLDP is enabled. This is the default setting.
• Disable. LLDP is disabled.
CAUTION: If the access point receives power from a PoE switch and you disable
LLDP, power to the access point might turned off after you click the Apply button.
In that case, restart the access point.
6. Click the Apply button.
Your settings are saved.

Enable or disable UPnP

Universal Plug and Play (UPnP) lets the access point be discovered by other devices in
the network that support UPnP. UPnP is enabled by default.
To enable or disable UPnP:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 41.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
Manage the Local Area Network
and IP Settings
147 User Manual