Disable A Dhcp Server - NETGEAR WAC510 User Manual

Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 41.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4. Select Management > Configuration > IP > LAN > DHCP Server Settings.
5. Click the > button to the left the DHCP server.
The settings for the selected DHCP server display.
6. Change the settings for the DHCP server as needed.
For detailed descriptions of the settings, see Add a DHCP server for a WiFi network
on page 151.
7. If you made changes, click the Apply button.
Your settings are saved.

Disable a DHCP server

The information in this section applies only when the system mode of the access point
is Router mode (see Change the system mode to Router mode or AP mode on page
162). If it is, the default DHCP server of the access point is enabled and you can also add
up to seven additional DHCP servers for WiFi clients only.
You can temporarily disable a DHCP server.
Manage the Local Area Network
and IP Settings
154 User Manual